Demeter Fuzzulator

OR

Introducing the FUZ-1 Fuzzulator, a different kind of distortion box. The Fuzzulator is the first fuzz box to use our innovative Tone Pre-Emphasis Circuit. This essentially works as an EQ stage to control and enhance certain frequencies, giving the distorted sound focus. The result is that even with massive distortion your instrument will not be lost in the sonic mud. The Fuzzulator also features an exclusive tight/loose switch which switches between overdrive circuits. The tight circuit uses LEDs as the distortion generator, whereas the loose circuit uses a special combination of silicone and germanium diodes. As with all Demeter products, these units are hand built in the U.S.A. using the finest components available to insure many years of trouble free use. This unit is True Bypass using an ALCO heavy duty Footswitch.

There are three controls on the unit: fuzz, tone and volume, a mode switch to switch between tight or loose, plus a foot switch to bypass the effect, and an LED to indicate effect operation. On the side there is a trim pot to set the overall gain of the unit.

Fuzz: Increases the gain of the distortion circuit, which clips and sustains the signal.

Tone: A high cut filter which you can use to make your sound warmer and fatter.

Volume: Sets the overall output of the unit. Use this for level matching between the effected and unaffected signal.

Tight/loose switch: Switches between light emitting diodes and germanium diodes for the distortion generating devices. LEDs have a tight sound and are a bit louder. Germanium diodes have a looser more classic fuzz sound with less output volume.

Trim pot: Sets the gain of the Fuzzulator's output amplifier. It is useful to turn it up if you are using the germanium diodes (loose) as your primary distortion setting. Or you can turn it down if the unit is too hot for your system.

There are two inputs on the front side of the unit: a 1/4" input jack on the right and a 1/4" output jack on the left with a battery-ground switch on the input jack.

Power supply: 9 volts DC. Either external or internal. For internal power, use a 9 volt battery. To access, remove the four screws on the sides of the unit and pull apart. Note: battery must have at least 7 volts for unit to work! External power supply using mini-plug, tip positive, 9 volt DC regulated (100 milliamp or more).

PGS One-year Replacement Warranty on All Pedals

  • Buy with confidence.
  • Hassle-free warranty replacement.
  • Fast turnaround.
  • We kick them, stomp on them, toss them and play them hard. They can take it. But on occassion a pedal may break down on us. PGS offers a One-Year Platinum Replacement Warranty that covers all new pedals purchased with us from manufacturer defects. Any manufacturer's defect in your pedal within one year of purchase will result in the replacement of that pedal free of charge. Units returned defective due to user error or incorrect powering resulting in a non-functioning pedal are not covered under our replacement policy.  In this case please contact the manufacturer for repair.

    Please contact us for more details on this policy or if you would like to use this policy on an item your purchase with us in the last year. (503) 670-4949.

    Lifetime Product Support to Original Owner for the Life of the Product